• by admin
• 2022-10-08

The correct installation method of rock wool color steel plate

For the construction staff, the correct installation method of rock wool steel plate should be known, as well as issues that should be paid special attention to during installation. In order to allow users to understand in detail, the following color steel plate manufacturers will introduce the correct use of the rock wool color steel plate in detail.

1. Installation of rock wool color steel plate for facilities and pipelines that require insulation, you should choose installation without leakage, surface dryness, fat -free, rustless and other conditions. In order to facilitate corrosion, appropriate coating can be taken.

2. Install the rock wool steel plate. In order to achieve the purpose of the heat loss, the manufacturer must make all the seams of the board and the felt to fully cooperate. During the multi -layer insulation, each cross seam must be staggered. Manufacturers should avoid the formation of hot bridges. When preserving cold, the cold bridge should be reduced to zero.

3. Rock wool products are used for outdoor insulation, or metal or plastic foreskins are used in places that are easily worn by machines. Pay attention to the sealing of the joints and seams. If necessary, it should be sealing, and the overlapping part of the protective cover is not less than 100mm.

4. Preservation also adds moisture on the preservation of the cold surface. Especially when the temperature is low, the moisture -proof layer should also be refuated with asbestos that does not contain resin.

5. When the temperature exceeds 200 °, the insulation should be properly protected, and the expansion may not change the thickness and volume.

6. Large diameter or flat wall equipment uses rock wool board to heat up. When more than 200, the heating nail should be added. The external care layer should be dense.

7. Rock wool color steel plate is placed vertically at the insulation object. When there is a considerable level, the insulation layer must have a positioning or support ring, and the distance does not exceed 3 meters. Use the manufacturer's insulation materials to slide down when vibrating.